EXPLORE MORE CATEGORIES
Industrial Pumps
Providing you the best range of low pressure pumps, high pressure pump and triplex pumps with effective & timely delivery.
Low Pressure Pumps
Product Price: Rs 80,000 / PieceGet Best Price
Product Details:
| Usage/Application | Industrial |
| Pressure | 0-70 Bar |
| Phase | Three Phase |
| Flow Range | 1-200 LPM |
| Available Motors | Hydraulic Motor |
| I Deal In | New Only |
We are authorised dealer with pump manufacturer.
Get Best QuoteRequest A Callback
High Pressure Pump
Product Price: Rs 1 Lakh / PieceGet Best Price
Minimum Order Quantity: 1 Piece
Product Details:
| Usage/Application | Industrial |
| Pressure | 0-700 Bar |
| Maximum Operating Flow | 0.1-60LPM |
| I Deal In | New Only |
| Electrical Ratings | 1 Phase | 3 Phase - 50 Hz | 60 Hz | FLP - Non-FLP |
We are authorised dealer with pump manufacturer.
Get Best QuoteRequest A Callback
Triplex pumps
Product Price: Rs 1.5 Lakh / PieceGet Best Price
Minimum Order Quantity: 1 Piece
Product Details:
| Flow Rate | 80-120 LPM |
| Head | Single |
A reciprocating pump design that utilizes three separate drive rods to drive the pumps plungers or pistons.
Triplex pumps are available in both single and double action designs. However, single action are much more common. Their design uses three drive rods, each at a 120 degree offset around the crank shaft. A single acting triplex contains the fewest drive rods in a positive displacement pump where the flow does not reach zero anywhere in the crankshaft rotation.
Triplex pumps are the first simplex pump to never fully reach a zero flow in the pump's cycle. However, pulsations are still present within the pump's flow rate. The flow rate will vary between 82% and 107% of the average flow. For example, if pumping at a flow rate of 100 gallons per minute, the flow will vary between 82 GPM and 107 GPM three times per crankshaft revolution.
A triplex pump also is the first reciprocating pump design in which the crankshaft design begins to alter the flow velocity. The peak velocity of each flow does not take place at 90 degree increments. The skewed maximum flow rate is caused by geometry conditions of the crankshaft and arm. The result creates an additional, smaller pressure pulsation which can be seen by the combined flow line above.
The flow rate produced by the pump will fluctuate from 82% of average, increase to 107%, decrease to 100%, increase back to 107%, before returning to 82%. This process takes place three times in every crankshaft rotation. The change may not seem significant, but running the pump at 100 RPM will result in this fluctuation 5 times per second. Careful attention should be given to the design of the surrounding system to prevent damage from pulsations and vibration.
Get Best QuoteRequest A Callback